PME Fault Detection Consumer Unit – 40A with kWh Meter (WMEPME10/SP)

The WMEPME10/SP is a metal PME fault detection consumer unit that WCED lists as a 40A C Curve model with a kWh meter. Energy metering provides a reading of consumption on the connected circuit.

Its published enclosure dimensions are 232mm wide × 240mm high × 112mm deep, the same external size listed for WMEPME08/SP. Select this model for the required metering configuration rather than assuming it offers a larger enclosure.

Key details

• Current rating: 40A
• Curve: C
• Metering: kWh energy meter
• Enclosure: metal
• Dimensions (W × H × D): 232 × 240 × 112mm

Before ordering, please contact Power & Data UK to confirm the fitted protective-device specification, SPD provision and meter details. Billing suitability depends on the exact meter and its certification.

Images are representative of the PME range and may show a different current rating or component arrangement.

Compare metal PME consumer units

Select by the required protection, metering and load-management functions. Confirm the fitted component specifications for your installation.

Browse our PME and PEN fault protection units for other configurations.

• Model: WMEPME10/SP
• Current rating: 40A
• Trip curve: C
• Function: PME fault detection
• Metering: kWh meter
• Enclosure material: metal
• Dimensions (W × H × D): 232 × 240 × 112mm

Please contact Power & Data UK for the exact fitted protective device, residual-current protection, SPD provision, meter specification, enclosure module capacity, IP rating and assembly rating.

Installation and commissioning must be carried out by a qualified electrician. Use the instructions supplied with the exact assembly and the charge point, together with the applicable BS 7671 requirements.

• Confirm the charge point's requirements for residual-current, DC leakage, overcurrent and PEN fault protection.
• Select cable sizes and protective-device settings for the load and installation conditions.
• Follow the wiring diagram, terminal identification and tightening torques supplied with the exact assembly.
• Test the protection and PME disconnection/reset functions using the manufacturer's commissioning procedure.
• Confirm the fitted protection devices, SPD provision and meter specification before selecting the board.
• Confirm the enclosure IP rating, module capacity and available wiring space.
• Check the meter wiring and operation during commissioning; establish the certification required if readings will be used for billing.

How does WMEPME10/SP differ from WMEPME08/SP?

WCED lists WMEPME10/SP as a 40A C Curve model with a kWh meter. Both models have published external dimensions of 232 × 240 × 112mm.

Is an SPD confirmed for this exact model?

Please contact Power & Data UK to confirm the supplied SPD provision and protective-device specifications before ordering.

Can the kWh meter be used for billing?

The meter records energy use, but billing suitability must be checked against the exact meter model and its certification.

Can I assume there is more space for additional circuits?

No additional wiring or spare-circuit capacity is specified here. Confirm the fitted layout and available space for the installation.